50Prices shown do Anti slip coatings for every surface!not include VATWatco Slip Resistant Chemi-CoatImprove safety in chemicalspillage areasEasy to use - simply roller one high build coat onto the floor then scatter the aluminium oxide grit over the surface while the coating is still wet. . Tough epoxy resin base resistant to many chemicals. Hard aluminium oxide grit for maximum wear resistance. Virtually odourlessUsage: Interior Suitable for: Concrete, sand and cement, metal or woodResistant to: A wide range of acids and other chemicalsCoverage: Approx. 18m2 per 4.5 litres per coatCoats: One coat is usually sufficientCuring time: Will accept light traffic in 16 hours at 15-20°C Normal traffic in 24 hours at 15-20°CSlip Resistant Chemi-Coat 4.5 litres: £160.70Roller/Frame & Handle: £29.40Replacement Roller: £6.80Watco Comfort GripA non-abrasive anti slip coating for pedestrian areasAn anti slip floor coating based on a heavy duty epoxy resin binder which is covered by rubber crumb. This gives a surface which is soft underfoot, less abrasive than most slip resistant coatings and has the effect of reducing noise. It is an excellent alternative to gritted surfaces for areas used by children or other vulnerable people who may be likely to fall.. Cushioned slip resistant finish. Helps absorb sound, impact and vibration. Uses recycled car tyresMain uses: Gives decorative finishes an anti slip finish without affecting the look of the floorUsage: Interior & exterior pedestrian useSuitable for: Can be applied to concrete, tarmac, asphalt, wood and steel(Not suitable for application to steps)Coverage: 5m2 - Coverage rate may reduce on certain open textured surfacesSlip resistance: Moderate slip potential - Wet PTV 30Coats: One coat usually requiredCuring time: 16 hours at 15-20°CComfort Grip 5m2 pack: £104.00Roller/Frame & Handle: £29.40Replacement Roller: £6.80BlackLight GreyMid GreenTile RedMid BlueTerracottaLight GreyMid GreenTile RedMid GreyGood resistance to acids, alkalis solvents, petrol and diesel

51For advice or to place an order Tel: 01483 418 418T: 01483 418 418E: sales@watco.co.ukF: 01483 428 888www.watco.co.ukAnti Slip Floor CoatingsSpecialist CoatingsGrip-Master Vehicle Grade approx 2.5m2 pack: £104.00Grip-Master Pedestrian Grade approx 5m2 pack: £114.50Grip-Master Rapid Vehicle Grade approx 2.5m2 pack: £114.50Grip-Master Rapid Pedestrian Grade approx 5m2 pack: £125.00Coverage rates may reduce on certain open-textured surfaces. Please specify colour when ordering.Roller/Frame & Handle for Pedestrian Grade: £29.40Replacement Roller: £6.80Notched Trowel for Vehicle Grade: £5.90Watco Grip-MasterAn attractive anti slip coating which is ideal for heavy wear areasWatco Grip-Master is available in two grades: Vehicle Grade and Pedestrian Grade. The Vehicle Grade aggregate is 1mm to 3mm in diameter and the Pedestrian Grade aggregate is 0.9mm to 1.3mm. Both offer a safer, highly visible, anti slip surface. Ideal for ramps or flat surfaces but not recommended on steps.A heavy duty epoxy resin binder is applied to the substrate by roller or trowel and the aggregate is scattered by hand and bedded in.. Extremely high slip resistance for vehicles and pedestrians. Virtually odourlessWatco Grip-Master RapidA rapid curing version of Watco Grip-Master. Ready for foot traffic after only 2 hours and heavy traffic after only 4 hours at 20°C. Ideal for use in public areas which need to be put back into use quicklyPlease note that after mixing, the working life of this product is approx. 10 minutes. The Watco Paint Mixer should be used to mix this product and the recommended coverage rates should not be exceeded.Usage: Interior & exteriorSuitable for: Concrete, tarmac, asphalt, wood and steel Coverage: Pedestrian grade 5m2 per packVehicle grade 2.5m2 per packSlip resistance: Low slip potential - Wet PTV 75-76Coats: Applied as one high build coatCuring time: Grip-Master: 10 hours at 20°C Grip-Master Rapid: 4 hours at 20°CVehicle GradePedestrian GradeHelps you meet DDA requirementsNatural GreyBlackOxide RedJadeNatural Stone