49For advice or to place an order Tel: 01483 418 418T: 01483 418 418E: sales@watco.co.ukF: 01483 428 888www.watco.co.ukWatco Safety Grip®Heavy duty, anti slip flooring system for dangerous areas. Provides extra traction in areas of severe slip hazard, even when wet or oily. Coarse anti slip finish. Withstands constant foot and wheeled traffic. Chemical resistant. Solvent-freeMain uses: Stairs, floors surrounding machinery, ramps etc. inside or out. Also ideal for maritime useUsage: Interior & exterior Suitable for: Concrete, sand and cement, wood or metal Slip resistance: Extremely low slip potential - Wet PTV 92Coverage: Approx. 5m2 per packCoats: One coat usually required.Curing time: Accepts light traffic in 20 hours at 15-20°CWatco Safety Grip® Cold CureOffers the benefits of Watco Safety Grip and will cure at zero Celsius (0ºC)Use in unheated areas, outside during the winter months or whenever the temperature drops below 10ºC. For easy cold weather repairs to floors before using Watco Safety Grip Cold Cure try Watco Concrex Cold Set (p10).Curing time: Ready for light traffic in 24 hours at 10°CRampsStepsAnti Slip Floor CoatingsCoarse Particle*A coat of Watco Epoxy Gloss Coat safety yellow (p27) or Watco Epoxyline yellow (p84) is recommended on darker substrates or bare concrete prior to applying Watco Safety Grip safety yellow** White and Natural colours are not available for Watco Safety Grip Cold CureBlackStoneSafety GreenNatural**Light GreyTile RedSafety BlueSafety Yellow*White**BuffMid GreyTerracottaSafety Red 1-4 packs 5-8 packs 9+ packsSafety Grip 5m2 pack £98.20 £93.30 £88.40Safety Grip Cold Cure 5m2 pack £104.50 £99.20 £94.00Roller/Frame & Handle: £29.40Replacement Roller: £6.80-10%Buy BULK and SAVE:-5%PricesHelps you meet DDA requirements

50Prices shown do Anti slip coatings for every surface!not include VATWatco Slip Resistant Chemi-CoatImprove safety in chemicalspillage areasEasy to use - simply roller one high build coat onto the floor then scatter the aluminium oxide grit over the surface while the coating is still wet. . Tough epoxy resin base resistant to many chemicals. Hard aluminium oxide grit for maximum wear resistance. Virtually odourlessUsage: Interior Suitable for: Concrete, sand and cement, metal or woodResistant to: A wide range of acids and other chemicalsCoverage: Approx. 18m2 per 4.5 litres per coatCoats: One coat is usually sufficientCuring time: Will accept light traffic in 16 hours at 15-20°C Normal traffic in 24 hours at 15-20°CSlip Resistant Chemi-Coat 4.5 litres: £160.70Roller/Frame & Handle: £29.40Replacement Roller: £6.80Watco Comfort GripA non-abrasive anti slip coating for pedestrian areasAn anti slip floor coating based on a heavy duty epoxy resin binder which is covered by rubber crumb. This gives a surface which is soft underfoot, less abrasive than most slip resistant coatings and has the effect of reducing noise. It is an excellent alternative to gritted surfaces for areas used by children or other vulnerable people who may be likely to fall.. Cushioned slip resistant finish. Helps absorb sound, impact and vibration. Uses recycled car tyresMain uses: Gives decorative finishes an anti slip finish without affecting the look of the floorUsage: Interior & exterior pedestrian useSuitable for: Can be applied to concrete, tarmac, asphalt, wood and steel(Not suitable for application to steps)Coverage: 5m2 - Coverage rate may reduce on certain open textured surfacesSlip resistance: Moderate slip potential - Wet PTV 30Coats: One coat usually requiredCuring time: 16 hours at 15-20°CComfort Grip 5m2 pack: £104.00Roller/Frame & Handle: £29.40Replacement Roller: £6.80BlackLight GreyMid GreenTile RedMid BlueTerracottaLight GreyMid GreenTile RedMid GreyGood resistance to acids, alkalis solvents, petrol and diesel