Bauder SS40 drainage and edge trimBauder SS40 is a perforated stainless steel trim used to retain the sedum blanket at open perimeters with external gutters and is suitable for both bitumen and single ply installations. It is automatically used on specifications where the roof slope exceeds 5°. Bauder SS40 prevents substrate erosion at the exposed edges of the blanket and, due to the excellent wind uplift and fire characteristics of the Bauder sedum blanket, may be used where a pebble vegetation barrier is impractical. The trim should be set back from the drip edge by 150 mm to prevent vegetation overhanging the gutter and impeding drainage. Bauder AL80/100 drainage trimBauder AL80/100 is a perforated aluminium trim that retains pebble vegetation barriers at open perimeters. The product is suitable for use with both bitumen and single ply waterproofing systems.Bauder inspection chambersThese should be installed above all internal rainwater outlets to provide access for inspection and cleaning. The chamber lid is secured with a single quarter turn slot screw fixing and has finger holes for it's easy removal. The base of the unit is slotted on all four sides to ensure effective drainage, has feet on three sides to provide a stable base onto the waterproofing and has a cut-away feature on the fourth side to allow for its installation at abutments to kerbs and upstands where either chutes or two way outlets are installed.If required, the height of the chambers can be raised in 50mm increments by the use of extenders. Bauder inspection chambers are available as either a full size unit for internal outlets or a semi-circular alternative for outlets positioned close to abutment walls or kerbs. If required, the height of the chambers can be raised in 50 mm increments by use of height adapter rings. 141 bauder.co.uk? Bauder inspection chamber with surrounding pebble vegetation barrier? Bauder SS40 Drainage and Edge TrimSpecification SupportNBS SPECIFICATIONSwww.bauder.co.uk/technical-centreTECHNICAL HELPLINET: +44 (0)1473 257671E: technical@bauder.co.ukEXTENSIVETECHNICAL GUIDE500mm min.150mm min.

bauder.ie142Bauder DSE20 - FOR ROOF SLOPES OF 1 - 5?Also For Extensive Roofs With Some Hard LandscapingBauder DSE20 is manufactured from high density polyethylene (HDPE) where the cupped profile provides water storage whilst allowing the water to drain through the channels on the underside. The design features of Bauder DSE20 means that it requires additional filtration, protection and separation layers within the specification.Bauder DSE20 will also provide a pressure resistant stable base for paved walkways or support for roof mounted equipment without compression of the drainage layer. The board depth of Bauder DSE20 provides excellent drainage characteristics, a high water storage capacity and is suitable for roofs with a minimum fall of 1°. This product may also be used on flat roof projects where standing water does not exceed 10 mm. Planting options: hydroplanting, where a wide variety of pre-selected plants are incorporated, plug-planting, when specific plants may be chosen, or pre-cultivated vegetation mats, where a mature vegetation sward is installed over the substrate.Material High density polyethyleneBoard size 1.06m x 2.36mThickness 20 mmWeight ca. 1.2kg/m²Water storage capacity ca. 7.4 litres/m²Compressive strength ca. 110kN/m²